作者：    来源：    点击：    日期：2007-10-1 9:37:14   

lbfactor must be > 0

　　# ----> Low lbfactor means less work done by the worker.

　　worker.tomcat1.lbfactor=100

　　# ------------------------

　　# Second tomcat server

　　# ------------------------

　　worker.tomcat2.port=8009

　　worker.tomcat2.host=192.168.1.34

　　worker.tomcat2.type=ajp13

　　# Specify the size of the open connection cache.

　　#worker.tomcat2.cachesize

　　#

　　# Specifies the load balance factor when used with

　　# a load balancing worker.

　　# Note:

　　# ----> lbfactor must be > 0

　　# ----> Low lbfactor means less work done by the worker.

　　worker.tomcat2.lbfactor=100

　　# ------------------------

　　# Load Balancer worker

　　# ------------------------

　　# The loadbalancer (type lb) worker performs weighted round-robin

　　# load balancing with sticky sessions.

　　# Note:

　　# ----> If a worker dies, the load balancer will check its state

　　# once in a while. Until then all work is redirected to peer

　　# worker.

　　worker.loadbalancer.type=lb

　　worker.loadbalancer.balanced_workers=tomcat1, tomcat2

　　#

　　# END workers.properties

　　#

　　#vi /usr/local/tomcat/conf/server.xml

　　　　
　　protocolHandlerClassName="org.apache.jk.server.JkCoyoteHandler"

　　redirectPort="8443" protocol="AJP/1.3" />　 第101行

　　在119行左右加入如下语句（去注释）

　　

　　若第二台tomcat，将jvmRoute的修改为tomcat2

　　系统整合完毕

　　启动apache和tomcat服务

　　# /usr/local/apache/bin/apachectl start

　　# /usr/local/tomcat/bin/catalina.sh start

　　将如下内容添加至/etc/rc.d/rc.local文件末尾

　　以便系统启动后开启apache,tomcat服务

　　#vi /etc/rc.d/rc.local

　　添加

　　/usr/local/tomcat/bin/catalina.sh start

　　/usr/local/apache/bin/apachectl start

首页 上一页 [1] [2]  下一页 尾页